Price on A/C lines?
Shipped to 48042?
For those of you that want convert to vacuum brakes and don't generate a lot of engine vacuum, you could use a vacuum pump.
I found this on eBay:...
I would like to change to mousemobile.
Let us know when or if this change will happen.
Or is it time to lock this thread?
I know this is a very old thread, but....
Are the anti-hop bars still available? I am at a point in my project where I have a "little" cash and can...
I was wanting the rotors to convert into hubs for a big brake conversion. IMO it would be a waste to cut up 'good' rotors.
Where's a good place to get these?
Do you have the front brake rotors?
WTF..... what is it exactly that you have for sale?
Is it from the C60 or C68 climate control system?
Bring back the old format.
I'm looking for an Air Dam for a Hot Air car.
Price, shipped to 48042?
If your bearing separator works well for you, great. Some case bearings can be very difficult and some cases aren't too compatible for...
It would be nice to see what you have, to help you and possibly give others an alternative set-up (if that is what it is).
If you have the corect tools for changing the bearing, then maybe.
Bearings, if good shape, can last 100s of thousands of miles.
If you haven't...
I had a fixed mast antenna. When the windshield needed replacing, I asked for a windshield with the built in antenna. My radio reception...
If you have gotten it apart, you might as well change the clutches.
I worked with product engineers and their opinion was that most limited slip...
Torquing it to 125 lb*ft will get it tight without crushing the sleeve any more than it was already crushed.
To crush the sleeve, you need upwards...
You may have overcharged it. The clutch drops out if the pressure may be too high or the system leaked.
At the very least, a good...
I had the same problem. I replaced the Shrader valve core and it still leaked.
The cheap, easy fix was to install another pressure...
If you didn't ruin the stock cork /rubber gasket, you can reuse it. I can't guarantee that it won't leak. Wipe down all the sealing surfaces (and...
IF the shocks are barely touching at FULL droop, they probably will not need relocation. With the car on jackstands and rear end...
Separate names with a comma.