For 1 and 2 a mig is best. 3 could be either. 4 is best with a tig. A tig could do all 4, but tigging thin sheetmetal can be difficult. You can...
I have one that has only been used for mock up. The sfi date is sept. 2011, so it's good for a few more years. I'll sell you a case that's been cut...
Existing sleeves shouldn't be a problem if you're going to sleeve all 6 holes. A good machinist can bore them to the point they just break free and...
This is a completely different pump then you have, but here is where and how I mounted mine. I'll make a stainless "hose" to connect the radiator to...
I got a lot of the front accessories stuff finished. I need the real motor to make the last few parts: cam sync sensor mount, drill & tap hole for...
.200" thick on the thrust sides is fair. You might be able to get away with a little thinner, but the rings seal will suffer.
I wouldn't be scared to sleeve it if everything else is good. Before you bother sleeving it check the max width of the combustion chamber in your...
Naturally aspirated or turbo?
When I'm done with it you can have it. :) What you see in the pics is a .060 over 109 block that has had a deck repair, an NA crank and a set of...
I only need two now
Yeah, I made this one so it's easier to cut on my bridgeport. Now that I know it's good I'm going to make it more curvy and send you material....
I'm pretty proud of this one. I've been thinking and planning this bracket for a while and it worked on the first try. It allows you to use an msd...
Yes, I'm going to switch it on high speed with the FAST ecu.
Why so much focus on maximizing finish line RPM, it has nothing to do with ET. Think about it, what is more inportant the first part of the track or...
Challenge accepted... :) I think it would be fun if the GS nats would allow some v6 vs. LS races so we can finally find out. They used to do BBB...
It depends on a lot of things. How much timing your running, radiator, pump, cylinder wall thickness, fuel etc.. I'm not sure what the coldest...
I would run it without a thermostat. If it doesn't heat up enough with an open hole, put a restrictor in it....
I would run it whenever the ignition is on and put a secondary switch on it so you can run it in the pits to cool the motor with the fan on. You...
Crap, I got your PM and meant to check on material but forgot. If you remember what I made the last one for, double it and send paypal to...
Back to work on my car and I'm not stopping until it runs. I got all the belt drive and front accessory parts setup so I can start making brackets....
Separate names with a comma.
