I was unable to stay for the actual racing due to business commitments related to the DNA lab but it was great to hear that finally we saw not one...
nothing general about my statement at all-------can't get any more specific than: heat is what kills coil packs-----and actually heat is what...
nick is 100% correct about the cause of coil pack failure----- its "HEAT"----- things like dirty electricity, bad grounds, weak alternators etc...
(continued) Re: Speedtalk posting: “Does ‘ADDING” Zinc to low zinc oils really help? If Mr. 540 Rat is comfortable using modern low ZDDP oil in his...
Re: Speedtalk posting: “Does ‘ADDING” Zinc to low zinc oils really help? In a July 12th posting by “540 Rat” he claims to have performed testing...
someone mentioned this thread and i will surely post a thorough response to it early next week. The DNA lab has me buried most of the time and it...
100 amps could be borderline------------if you send it to me i can check it and upgrade it if needed-----------usually costs less than $80 for...
and don't forget that each of the pairs, ie 1 and 4 are interchangable with each other to make wiring neater-------if you mount the coils so that...
the current (amperes) output by an alternator is actually a demand thing---------the amps output from an alternator vary depending on the need of...
over the years i have dealt with Paul and personally have had no problems------some seem to have had problems and i do not really know all the...
shake the gas out of them as best you can and put a few drops of light oil (3in1 is good) in them to prevent rust-------------may not be necessary...
i am on the road this week and cannot answer your question for sure-------they are at 12 and 6 oclock but i believe the distance from bore center...
if you are using a stock servo there is a really nice GM tool that lets you get a very precise measurement without removing anything but the servo...
just realized as i was posting that i forgot to look up the dimensions for the extra 9 - 14 holes for stage heads---------i will get to that this...
here are the basic dimensions for the holes taken from the original factory drawings--------several things to keep in mind--------looking at my...
you say it has been "ragged" a bit-------is that the same as "beat on"-------sometimes these high tech terms are hard to quantify :)...
I plan to post the info necessary to make the torque plate late today or tomorrow--------as for the plans i believe the date is 85 but dont...
its not that easy----------these are actual working blueprints and spread out on the floor side by side they are over 10 feet long--------i was...
i prefer to use a washer of the right size to seal the cavity so i can put lots of pressure on the RTV-----that seems to squeeze any air...
Separate names with a comma.
