You need a new ignition module to go with the new coil pack. Removing the goo is not going to help.
I just did a quick search on ebay and found a brand new gas tank for a 1987 buick grand national. The price is $86.99 shipped to the lower 48...
Wow you really need to share where to buy from. I bought one in 2001 for my 86 T-Type from advance auto parts and it was $150.00
You can order a new gas tank from your local auto parts store for about $230.00. It shouldn't take more than a couple of days for them to get it...
Advance auto parts has a better price on the BWD coilpack,or they did the last time i looked on their site. I've been using the BWD brand coil...
Yes it goes on a post by itself, seperate from the other large terminal ringed wires. Heres a link to a mini starter that has photos showing this....
I have the autozone duralast module on my engine and have for a few years without any problems. That's the only ignition part i have from autozone,...
How old is the coil pack and ignition module? i would have them tested at an auto parts store. You cold test the coil pack if you have a digital...
You need to put the screws back in that hold the bezel and gage cluster pressed firmly seated into the dash so it makes a complete circuit so the...
Ingersoll Rand has a cordless impact wrench that is 20v and has 780 ft lbs max reverse torque and 1100 ft lbs max tightening torque. I've seen them...
It seems the block everyone needs to make big hp is already available from TA Performance the aluminum v6 block. I personally don't need the hp of...
I just installed the aluminum blower motor wheel from autozone $12.99 plus tax part number 35601. It made a big difference in the amount of air flow...
I got a lot of those parts also,and still have them on the car and running good.
Conley's Performance Parts made the same claims about their parts also in their catalog. There may have been others that did also but i do...
Did you get new lifters with the new cam? if not that could be part of the problem along with the pushrods.
It's almost inline with the rear of the drivers side door,bend down right at the end of the door and look up behind the frame and you will /...
New valve springs and adjustable wastegate rod or high boost wastegate also.
I don't remember the length of the pushrods off hand,i have it written down in my notebook i'll have to look through it. I used an adjustable...
I can't answer your question about iron heads,but. I have the same setup as you; GN1 heads, T&D shaft mounted roller rockers, Comp roller lifters....
I've had them tested before at Advance auto and Autozone and the test equipment did show volt output. I would get a second opinion from another...
Separate names with a comma.
