Pulled the pan on a buddy's new TTA tonight to change the rear main seal for him and clean out the pan/pickup. He had blown a headgasket due to a...
So I recently had my TE61 rebuilt by a reputable local turbo shop, seal was leaking. Shaft play wasn't bad. Engine ran fine although smoked at idle...
So after driving the Z28 for a year I really enjoyed the handling, and now that it's sold I'd like to upgrade the T-Type so it drives better. I've...
So . . . changed header gaskets last week, screwed it all back together and voila . . . runs like crap, as if it had a bad MAF or something. Poor...
Cross Drilled & Slotted Brake Rotors Ceramic Pads Front: eBay Motors (item 220645879116 end time Aug-29-10 09:55:40 PDT)
So as per my earlier post, my suspected headgasket turned out to be not. When I disassembled the valvetrain I found that the intake valve seal was...
Pulled things apart tonight to change to TA headers & found turbine wheel to be WHITE. Pulled off the old headers, all white inside. Check the...
After bolting on some 245/45R17 rubber my 86 T-Type bump steers and follows the road ruts BAD. All the bushings are pretty new and the alignment is...
What would cause a boost spike on a dead stock setup? Shoots up to 17 or 18 psi in first, then settles to 14 psi, then spikes on each shift to 16 or...
I've been running a TE61 with a 3000 stall converter for a couple of years now and love the way it pulls. However, I've also been driving a couple of...
Has anyone ever used one of these? AEM - TRU-BOOST Gauge-Type Controller Apparently you enter your wastegate spring pressure and go from there....
Anyone ever used the door handles, window motors, or any other stuff for TR's from 1AAuto? How is their quality, fit, and function? I've searched a...
Put on an RJC Boost Controller and I can't seem to get the boost I'd like out of it. 1/4" tension on the wastegate rod, RJC halfway in = lazy 15 psi....
On my 86 T w/ 44, FM, 57's, & alky she runs like a top at all times, at around 22-24 psi WOT, no knock atall - - until I lock the TC. Then she...
My DS header is leaking again after welding & planing, etc, getting too thin. What's the best bet on a new header? GM? ATR? Anyone try the Poston...
Is it much of a jump to go from a TE44 to a TA61? I've been doing a bit of research on this and all the latest stuff is on the PT61 or GT61P. This...
I've been thinking of upgrading my stock IC for some time now, and came across 2 GMHTP tests that were interesting. Jan. 04 they tested the new...
All of the recent talk of the GT series turbos has me itching to try one. Currently I'm running a TE44 w/ 009's, stock IC, ported irons, & 3000 stall...
Just did a leakdown test on my 25,000 mile rebuild. At TDC, cyls 2 to 5 were 10-13%, #6 was 20%, and #1 was 45%; at BDC or with a little oil #1 read...
Separate names with a comma.
