First off, if this is the wrong forum I apoligize, please move it to the correct one. This is not intended to be a for sale ad, I'm honestly unsure...
Pulled my GN out of storage the other day and noticed it's not hitting on #3. Diagnosed it as being #3 by pulling injector harnesses off of...
Anyone know if all Regal rear supports are the same, or if they have to be from 81-87? Found 4 aluminum rears today in the jy:D, but 2 of them were...
Seem to remember reading that the drum brake 3rd Gen's used the same odd style axle flange as 8.5 10 bolts. If so, while this does require some...
One of the T-tops on my GN has been replaced somewhere along the line and I'm wanting to get the correct one, would an 87 have locking(with a key)...
Over the winter while my car was torn apart to replace a dead cam I installed an Extender chip and new 50# injectors. Upon getting the car running, I...
For some reason the converter isn't locking up after I put a new cam in a couple weeks ago. Was working just fine last fall when the old cam bit the...
Just got the motor fired up with the new cam(204/214), broke it in right, changed oil and did all that stuff. Was going to put gas in it and noticed...
Trying to splice in the Ramchargers dual fan setup, does anyone know which wires in the stock harness control the stock fan-high/low speeds? Thanks...
Just about done putting the GN back together, and I'll be damned if I can't remember which vacuum lines go where... Does one of the hard plastic...
Going to be buttoning up the front of the motor hopefully tomorrow, is there a procedure for setting the crank sensor as far as clearance and whatnot...
Anyone got a good way to clean out an oil cooler? Just something that will get some of the metal that is no doubt in there after flattening a lobe....
Anyone know the clearance spec on the rod bearings? Gnttype lists it at .0005 in. - .0026 in, is this correct? Just asking since there seems to be...
Are the converters interchangeable between them? Namely, could a restalled D5 be put into a lockup 700R4? Buddy of mine is putting a 700 in his...
I can get a good price on Speed Pro stuff through work, but our catalogs don't have a listing for the 214/224...Does anyone know the part number for...
Pulled the pan and a couple mains/rods off Friday and found that the crank is turned 40/40... :( Now I get to decide what to do. I pulled the caps...
Trying to find out the route that oil takes through the motor-where it goes from the pump onward. Anyone able to describe this, or know of a diagram...
My GN was keyed up pretty bad on New Years Eve, and the insurance company cut me a check to fix it, but I can do some of the work myself like...
I'm going to need to pick up some taller valve covers to clear the T&D's, but am unsure as to who makes what ones and how much they cost, could some...
Decided that after losing the cam with only ~8,000 miles on it that I'm just not going to risk hurting the motor any more with another flat tappet,...
Separate names with a comma.
