YES I DO HAVE 3 BAR MAP AND BOOST IS CORRECT IT JUST SEEMS ON MOST OF MY PL FILES THE KNOCK IS USUALLY AT THAT POINT AT 2/3 SHIFT AND WHEN TIMING...
It seems i get knock when my timing changes from what it is set at in low gear to high gear, but no knock after that most of the time. was wondering...
thanks for the feed back on turbo question i'll be trying to get it down to low 11's when zmax has test and tune and when if finally stops raining,...
Hey bison this is stevek on turbo buick forum, if you could take a quick look at my pic of turbo in turbo and related parts, see about size and your...
[ATTACH][ATTACH][ATTACH] I just removed my turbo and was wondering if this is an te-60 turbo, It spools fine 28-29 lbs with no play . I got it as an...
I made a run on PL without e85 and then with some e85 , 3 gallons to about 3/4 tank i believe it made a a big change. It felt really strong, I...
I have a small problem with my fuel guage on my gn. it seems to go all the way past full and out off sight when i turn key on and then moves back up...
looking nasty good
hey thanks for the reply ill see if i have old one around but the one that i put on the unit before sending it to cardone was just purchased from...
I just had my power master brake cylinder rebuilt at cardone, my pressure switch was replaced there but it seems to have a small leak around base of...
David Husek, trans working great and great guy to work with.
yes i do tt6.1 chip
I have a question about adding fuel with power logger, what is the difference if i add fuel i guess by raising the BLM # on the powerlogger say from...
Just put SPOOL FOOL'S front fillers on, very easy instulation after watching his video, they look great and i wish the rest of my car looked that...
I just purchased a new brake pressure switch from kirban and wondering about the o-ring that is installed on it, it is installed on switch just past...
thanks for reply
I switched over 295/55/15 MT tires from 26 in., taller tire just wondering if ok to run without changing the speed gears, i'm running 20 lb in them...
thanks for feed back just ordered from kirban's thanks again
I think that is what it is called, it is located on back of power master, mounted on top, screwed in with plug connected to it. mine seems to leaking...
Turbo drain tube is dry, where it goes into block it is little damp looking but looks damp even above tube inlet into block, the driverside of...
Separate names with a comma.
