Recent content by anders

Not really, someone here must be running aftermarket ecm and know if you chould set 26 degrees past tdc like stock setup camsensor ,or is it not nessesary whit aftermarket ecm.

Hi If you have an aftermarket ecm chould you still set the timing 25 degrees pass zero ?

Hi It semes that the 214-214 cam is hard to get, What is the rpm range numbers for that cam? Does someone now where to get one?p

Hi Ineed some advice to get faster 1/8 times and 60 foot. must be running 10.5x26 slicks class should i go with higher gears ? Launch boost? Start in second gear? Car weigths 3600lb What combo do you have to run mid to low 6 sec? My best et 1/4 10.27 but i am only going to race 1/8 in the future.

Hi Ok what tire size did you have and what was your transbrake set up st launch? I have never came under 1.67 60 foot. What was your rwhp. and at what boost? How high do you rev it? Anders

4340 steel forgeed and girdle

I used to have a 212/212 in my old 3,8 engine and i liked it and the different in peak power isnt that big

About 6500

Hi! I am running the 224/224 cam today but thinking of install the 218/212 cam to get some power earlier and spare the engine from high rev all the time. Engine is going out anyway for piston rings change. What do you think of that? Anders

Ok thanks How much can it be Worth, its a non drilled block.

Hi! Does any one now what type of block this is and can it be used with buick heads/parts? Anders

For a TH400

Hi can someone help me were i can find a PTC 9.5 race converter about 3800 stall

Hi! Today i had the TTA on dyno and it dont like to make any moore power even with extra boost, same hp from 21 to 26 psi. Se the attached file. I dont like this camshaft 224/224 i am current running, my old 212/212 was more fun at lower rpms, i am going to swap in a 212/218 soon and hope that...

Hi! Is there any replacement for the stock camsensor ?