Recent content by juan89

  1. juan89

    SD2 issue with BLM ?

    I am having an issue in where I have to adjust the BLM as follows on the attached file. The engine is stock with a 206/206 flat tappet comp cam. The injectors are 42Lb Lucas disk. When I use any other MAF chip including a Maft PRO speed density, is just fine as is. Thanks, :)
  2. juan89

    What turbo should I get?

    The price is 799.00 for the ball bearing and billet wheel. I ordered one.
  3. juan89

    What turbo should I get?

    Best turbo for a stockish combo. It is a ball bearing turbo so, it works with a stock converter. Best bang for the buck. I just ordered one .
  4. juan89

    What turbo should I get?

    Check link below :) https://turboneticsinc.com/store/index.php?route=product/product&path=35_58&product_id=709
  5. juan89

    Balancer spacer for pulley

    PM sent on spacers to turbobitt. Juan
  6. juan89

    Misfire problem

    Check for a cracked spark plug.
  7. juan89

    Misfire on #4 on semi fresh rebuild after track outing

    Connect a noid light on the injector plug, to see if the ECM driver is working .
  8. juan89

    Misfire on #4 on semi fresh rebuild after track outing

    https://turbobuick.com/threads/cylinder-balance-test.463937/
  9. juan89

    87 GN intermittently “skipping””

    I had a similar issue . It was a cracked spark plug. https://turbobuick.com/threads/cylinder-balance-test.463937/ Juan
  10. juan89

    Cylinder balance test ?

    I did the balance test by disconnecting the IAC. And found a bad cracked spark plug. Thanks Everyone, Juan
  11. juan89

    Cylinder balance test ?

    Thanks, for the tips. Juan
  12. juan89

    Cylinder balance test ?

    I read the factory manual and it said to disconnect the IAC connector after starting the engine.
  13. juan89

    Cylinder balance test ?

    How do I do a cylinder balance test on a turbobuick ? When I disconnect a cylinder , the IAC will bring the RPMs back up. Is there a way to Lock the IAC position ? Juan
Top