Recent content by Quickturbosix

Mike - Whatever man I will send you your $40. What I think is bullsh%t is you donate a intake to a project and when it doesnt look as if you are going to make a ton of free $ from it you want to charge for it 6 months later. And by the way its a crossmember I owe you for not a driveshaft. As far...

I hate to do this.... Bo McDonald aka underpress aka limited_1@hotmail.com sold me a motor that "needed nothing" and was "ready to run just drop your crank in and go", yeah right! I asked him about the cylinder walls because the pics he sent of the motor were not very good. He said the...

Is the chat room on the fritz? I tried both irc and the camaro board and get nothing...:confused: :(

I'm game! :D Got a feeling my Ford is going to hurt that Dodge. :eek: p.s. Picks of the Ford in the sig. ;)

http://forums.planetice.net/showmessage.php?message_id=304371 It doesnt get any better then this!!!!!!!:eek: :D :eek: :D

Thats a nice piece! Do you sell the block off plates? How much for something like that engraved?

If you look in the seat area there is a small plastic box. It should have a cover on it that opens. Inside there is a metal strip about 1" long. Check to see if its melted in two. If so then the start and or solenoid is froze. Even if its still in one piece my guess is the starter or solenoid is...

Most people call me the Repoman but I prefer Finance adjuster. :cool:

Is this for Chicagoland members only or can a outsider from Indiana show up? Sounds like it might be a good time. :cool:

They screwed me for $1000 as a seller, long story. Something you may want to read www.paypalwarning.com

Indiana plate - "JUSTA 6"

If it wont come down cant you just change the spring in the pump?

FG parts - http://www.vfnfiberglass.com/8187regal.htm http://www.tokenfiberglass.com/catalog/show_sub_cat.asp?cat_id=12#188 and Cotton sells fg parts but I dont think they are on his site. I hear his doors are pretty nice. http://www.cottonsperformance.com/ Keep a eye out about...

Shooting for mid 130's @ 10.50 or better. :) Combo: lt70, 72's, powerstroke ic and 3" plumbing, Lunati 224 cam, KB 70mm tb and plenum, ATR ported iron heads, ported lower intake, stock ported headers, BGC stainless crossover with Racegate, Trans + with extender, 3.5" maf, AC 9" 4000 stall non...

I just bought one from www.swracecars.com If you dont mind doing the work yourself you can save a lot. Most bars or cages run $100 per point to have them installed. If you call S&W ask for Stokes and tell him Dale sent you. Very nice guy to work with.