You can type here any text you want

Recent content by spaulding

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
  1. S

    Huge Crowd For Biden

    Lets Go Brandon!
  2. S

    No start

    One done, 3 to go.
  3. S

    Wanted, hot air thermostat housing

    My hot air thermostat housing is leaking, multiple pin holes, rusted, anyone have one for sale in good condition? Thanks, Spaulding.
  4. S

    No start

    She runs, tried to upload a 40 sec movie but the site didn't allow it.
  5. S

    No start

    Update: Checked crank sensor and found signal and ground were wired wrong (by me). I found this using the caspers website tech pages and putting my wire routing/diagram on notebook paper to keep it organized. Next, using a 5v wall charger for an old cell phone and a multimeter, I checked the...
  6. S

    No start

    Thanks Dan!
  7. S

    No start

    Computer and chip(s) if anyone is knolwledgeable please let me know if these look ok.
  8. S

    No start

    Yes, I just finished testing continuity from ccci to computer (5) total wires and all have good continuity and are in the correct locations. Still need to check white tach wire and trace it to instrument panel. Checked rotation of cam reluctor/interrupter under cam sensor cap and it is rotating...
  9. S

    Another MS3Pro Evo build

    Thanks, I have an old holly projection I was thinking of using but no manifold. I appreciate your input and will probably look around for an 86-87 manifold.
  10. S

    Another MS3Pro Evo build

    Hi Shawn Great job on your engine build. I am thinking of doing a similar swap, would you recommend getting the 86-87 intake manifold or are you happy with your choice of intake, throttle body, and injectors.
  11. S

    No start

    Guys here is what I have so far using Casper's sensor check tool: With key on: power, crank and cam lights illuminated (bright and steady) on test tool. With engine cranking over: power, crank and cam lights same, not blinking rapidly as stated in instruction sheet. Moving the switch on tool...
  12. S

    No start

    Here is where I am so far: Chart c-4a 1. no spark on 1,3,5 4. .3 volts at b-5 Chart c-4b 1. a-11 volts .3 2. a and b volts 6.4 2a. a and c volts 11.5 4. crank engine volts 4.3 steady, not varying The tree states: not ok faulty sensor I have replaced the cam sensor, and still have the same...
  13. S

    No start

    Thank you for your generous offer, I am going to make sure I have power at all sensors and the injectors, then check all fuses again. I will let you know if I need the tester. Question regarding the fuse block, do you know if any of the single point fuses labeled ign 1, 2, and 3 need fuses? They...
  14. S

    No start

    Just read it and will check it on my crank sensor tomorrow. Thanks for the pointers/tips.
  15. S

    No start

    Thank you, it looks like I have the correct computer for the car. Still have no spark and no fuel after new crank sensor, cam sensor and 86-87 ignition module conversion. Frustrating, back to the no start tree!
See more

Online statistics

Members online
38
Guests online
369
Total visitors
407
Totals may include hidden visitors.

Newest members

Stay Connected

Back
Top