XFI Trans creep

karolko · Feb 9, 2016

was wondering how slow you guys have gotten your trans creep down to: looking to slow mine dow a little more than this:

Also it appears that it starts fast and then slows down a bit, usually it is suppose to increase in speed as time goes on.

i ave the pulse set to 20 and the acceleration rate set to 1, start and creep set to 9.8

Thanks for the help.

Adrian

J-B Racing · Feb 10, 2016

I have mine that from the first stage light, it bumps to the second. Minimal time as possible to waste. Every second on the Brake is 100 degrees of heat added to the transmission.

karolko · Feb 10, 2016

JB, just to give me an idea, how long do you have your time set at. I know it will vary on how fast your creep is, but give me an idea.

PS: do you know the physical distance between the first and second beam? It should be universal.

Thanks in advance,

Adrian

pacecarta · Feb 10, 2016

about 6-8" of roll from prestage to stage beams

karolko · Feb 11, 2016

i am wondering how many people use the timing function to control the amount of roll the car gets. if it works, that would be perfect, but if i stage slightly shallow to deep into the prestage bulb and the time the trans creep works is a little to short, i fear i might light up the stage bulbs and then what?

I'm curious what guys are doing? Leaving the time function to 25.5 seconds or setting a specific time?

Huh.

XFI Trans creep

karolko

Well-Known Member

J-B Racing

Forced Induction

karolko

Well-Known Member

pacecarta

LOGGED OUT

karolko

Well-Known Member

Similar threads