Search results

This may sound stupid but here I go. I took my front seats out to put on my new seat covers and I don't recall how to route the wire that goes to the power seat control. Does anyone have a picture. Thanks in advance for any help. Ted

Hello all I have just bought a home in Port Alberni on the Island and was wondering if any members reside in or near Port Alberni. I'm moving from Ontario in Aug. Thanks in advance Ted

This happened with 600 mile on a new build!! It happened driving for coffee no boost, 5 to 10 pounds max if any. Will it ever end? Just before the crankshaft went both my wife and myself stated how good it sounded and ran. Not two min later, we noticed the sound. No smoke, nothing. I lifted...

I'm looking for a forged crankshaft. Please reply if you have one for sale. Thanks in advance Ted

Looking for 3 inch down pipe or complete single shot exhaust with downpipe. Thanks in advance Ted

OK guys I need help!! New engine built 500 km on engine. While in boost it burns oil. The engine makes 80 - 100 pounds of oil pressure. Oil pours out the Dip stick????? Can anyone tell me why and how I can fix this problem??? Thanks in advance Ted

Hello all I'm looking for a part number for a check valve to put between my PCV valve and my vacuum block. When I'm in boost my PCV valve is sucking oil into the vacuum block. I thought I had a blown turbo or worst until I did some research on the forum and learned a check valve may do the...

I removed my complete A/C and heater. Installed a delete plate and delete pulley. I also installed G Body Upper tubular A arms. Now my front end is sitting higher then the rear. What can I do to fix this problem? Thanks Ted

Looking for a Steel coolant lines that go to the heater from engine. Thanks Ted

I removed my A/C and installed a delete plate. I ordered a heater from Summit and I want to use my stock fan switch. Is this possible and if so what do I have to do in order to make it work. Thanks in advance. Ted

Stock Cam and lifters Stock Torque converter Stock Turbo Stock down pipe Stock valve covers Stock Heads .20 pistons TA 60 turbo never installed since rebuild. Grand National Rims with BF Goodrich, Radial T/A Front P225/60R15, Rear P245/60r15. Rims are not show but very good All part...

I'm looking for a pair of champion fuel rails. Thanks Ted

I have bought a Translator from a member on the forum and need a cross references for 3 inch MAF. Any help would be appreciated, I'm going to the bone yard to buy a used MAF and I need to know what make and year of the vehicle to look for. Thanks Ted

I'm rebuilding may 3.8 Grand National motor and I am looking for Crank, pistons 020 over and piston rods. Thanks Ted

Translator+ and 3 "LS1 MAF Thanks Ted Drive Safe

Hello all I'm looking for an alky kit it can have one nozzle or two. I'm planning on installing it in my 87 Grand National. Thanks in advance Ted Drive Safe

I'm looking for a good set Iron Heads as I'm upgrading from stock. Thanks in advance Ted Drive Safe

I'm looking for a 3" stainless Y pipe from the Cat to the differential. Thanks Ted Drive Safe

Hello again Just when you think your finished, you find something else you need. I am looking for a cold air intake with cone 9 inch K&N filter. I'm going to use my stock MAF but I would like a chrome Tube to replace the stock one. If anyone has something that would work please PM me. Thanks...

Hello all I'm looking for a direct scan or Scanmaster, I have a laptop! If anyone has a direct scan or Scanmaster for sale please PM me. Thanks in advance Ted :tongue: