Search results

TE63 Qtrim with .63 ex housing...4" polished compressor housing. Turbo has less than 200 miles......$750.00

Currently I run a PT 67 Q trim with: ported iron heads, FAST system, 83lbs, 3500 stall Yank LU, ect.... My turbo spools sloooooow. Help. Can I convert this turbo or do I need to replace it? thanks

What is a good replacement alternator for the TTA?

What are the options for the Upper and Lower Radiator hoses on TTA?

I have a PTE bilet roller cam that has broken the cam gear. Does anyone know where I can get that OddFire gear? PTE referred me to Dan, but he has not returned any of my calls.

Thinking of swaping rearend assembly to a Strange or Moser 12 bolt set up w/ Eaton posi. Any info to help decision would be appreciated.

Anyone got any ideas on what to plug the factory breather hole on the driver's side valve cover with. Just got a METCO breather to replace the cap and need to block off the other. Thanks

Sometimes when I try to start my TTA the fuel pressure gauge reads "0". If I bump the switch a few times it will finally kick the pumps and get pressure then start. When I cut the car off, the pressure "sometimes" drops back to zero..sometime it will hold pressure. Regardless, the car will...

I have a FAST system with the lockup on a switch. Lock up works fine untill the tranny gets hot. If it is lock when that happens it take about 2 min to unlock. If it is unlocked it will not relock until the car cools completely down. The tranny was receintly converted back to lock up and is...

Recently switched my pump back to lock up and put a Yank SY3500 lock up in place of the old AC n/lu. Took the car out for a test today and experienced the folowing: I have FAST so I put a toggle on A and F in ALDL to create a manual switch for lu. Got the car up to speed in drive, flipped...

I know Magnacor make these but have heard negative warranty issues. I have been making my own from Taylor universal kit, but is there a GOOD wire that will fit perfect with the THDP( prefer Blue). Thanks

Boogered the threads on on of my intake to head bolts. Does anyone known the tap size needed to clean it up? Thanks

I've got my heads off to repair blown HG and wanted to replace the rocker w/ roller. I've seen where several of you guys have put them on and wanted to get the info on the swap. First, what rockers did you use. Were they the 7/16" for the V8 Pontiac? If so, what did you do the the...

Would the back of the intake(under the coil pack) be a good location for the sensor...no negative effect? How would this compair the in the uppipe?

Cut the upper radiator hose and spliced it for a quick fix. NAPA, Advance and AutoZone all do not list the upper hose for the TTA. Anyone got the correct part number or source. Dealership not open and I'd like to get it together today. Thanks

Looking for aluminum, or stainless 4" MAF pipe for TTA to go with new PTE 4" turbo housing. Not really wanting to run flex type hose. Thanks Kevin

Anyone had any experience putting GN1s on TTA Engine? Are there any engine bay mods, or do they fit OK? Thinking of going StageII