Search results

Went to the track this weekend and ran a 10.12 off the trailer. Next pass was a 9.99 @ 134 The last pass was a 9.98 @ 135.5 6.38 @ 110.0 1.52 60' I think it is time for some new slicks!!! Without the wideband input for the max-e i would be putting the car away for the year without a 9...

With a timing light i am getting 8 degrees of timing at idle. And it stays there when the rpms are brought up to 2000. If it idles for more then about 10 min. the headers will glow orange.

When will we be able to use the search feature again.

I have seen some type of launch controller advertised that works with the linkege. A link to this or what it called would be great.

Is there a on-line rule book for nhra/ihra I did a search and did not find what i was looking for.

What spring pressure and what lash are you running. And do you have hyd. lifters that were converted to solid or solid roller lifters.

Where can you buy the black push pins that go at the ends on the weather strips.

Does anyone have an open account that would run a # for me.

Looking for a 3.5" crank pulley like bgc sold.

looking for Any pics of glass or alum. seats that have been covered for a turbo-t or t-type

Do the copper gaskets have to be retorqued often. I am just trying to decide between steel shim/cometcs or the new ics titans when they come out.

Can the speaker cover in front of the dash be removed with the windshield in place.

What is required in a cage to go 9.90 I was at the fab shop and he was installing a cage and off the main hoop he had put bars down at a 45 degree angle that went into the aera around the mounting point for the lower control arm. It looks like if that was done on a regal those bars would...

Where can you get a a/n fitting to go into the fuel psi regulator.

I need to find a new t-stat housing this week. Who keeps these in stock???

What are the torque spect for the shim gasket with arp studs.

tsm qualifing time on sat? Gates open on sunday? Do they sell beer at the track? If not can you bring your own? Spectator admition sat. and sun? How far from St Pete's?

Aneyone running k-b mild steel headers Just wanted to know how these hold up compared to stainless.

Anyone who is running this turbo over 24 psi...what cam profile are you running and what lobe center? I have a gt-71 compressor wheel turbonetics 4"inlet 2.5" outlet cover. Gt-q turbine pte .63 housing. It will not make more than 24 psi??? I have been told it may be the cam i am running...

Does someone have a cam card or know the lobe center of the 218-218 469-469 comp cam