Search results

Okay guys I'm going to start my lq9 swap into my 1985 buick regal was stage 2 v6 before. I got a lq9 and it utilizing my 200 r4. I have moroso steel motor mounts wondering which motor mount plates i need. I'm assuming it need flexplate adapter (bushing) as well. Also need a different oil pan as...

Can anyone tell me if a ls holley midram intake with clear the hood on a buick gbody with bubble hood???

Will a holley ls1 midram intake fit under the stock bubble hood on the buicks or no????

going to pick up a done lq9 has lots of goodies the cam specs are part number is comp cam 289/293 duration 624/624 lift and a 114 lobe separation. my question is cam I run this cam with a turbo set up

Looking for a blue buick t-type steering wheel must be in good condition and willing to ship to canada thanks

i got a stage 2, took it out today when building up boost the car backfired a few times then stalled, i coasted to a stop, pulled a wire off the coil pack held it and turned it over there is spark put a coil tester on that looks good but still will not start anybody can ya hlp me could it be...

Selling my 1984 buick t-type stage 2. All leaded race fuel was ban in canada. Car runs on vp-c16. i bought the car from the states and had it imported to canada had it for just about three years don't really drive not to sure how to tune. Car is in swan river manitoba, canada asking $20,000...

whats the best oil filter for these stage 2 cars just bought one in the fall and its time to change the oil "thanks guys"

looking for a c-com interface serial cable for my accel ecm on my buick stage 2 car so i can go on to a laptop

noticing trans fliud on top of my intake any idea where its coming from. thanks

is there other cars by gm which the serpintine pulley off the crank that are the same as the 86-87 buick grand national. thanks

looking for a stock crank serpintine pulley for buick 3.8

put a new iac in my car its reading 00 at idle when warm and goes to 03 when fan cuts it need to be adjusted looking for help thanks.

anybody in canada got a good ignition module need it by next weekend its yorkton saskatchewan drags.

any body in canada have a good ignition module forsale. i need one for next weekend its yorkton saskatchewan drag races.

i took my car out today and drove it for a bit and it stalled while i was driving. i waited a bit and it fired up, so i hobbled it towards home it stalled again. so i started it again and got it home and left it idle and recorded the numbers. these #'s are at idle when i got it home stalled...

can a guy buy a replacement fuel line kit for these cars(1987 tr) from the tank up to the filter or do you have to make one. thanks

wondering whats up my brake lights just quiet working have all other lights but brake lights even the thrid brake light is out( the one on the rear deck). would it be the switch on pedal or a ground. the fuses look good.thanks

are stage 2 cars very trouble some or are they ok. or are they a pain in the a-- and a big expense. looking at getting one just to have. and maybe race once a year, 1/8 mile rest of the time look at and cruise a bit.

anyone out there know where else i can get a LS1 maf for same price that full throttle sells them for. 109.99. they don't answer there phone or what i can't get a hold of them.