Search results

I have for sale 2 rear Comp Engineering shocks. I have decided that this is not my direction I want to go in. I have decided to go with some Konis. One is in the box and one is installed however I will remove one they are sold. I am asking 125 for the set and I will ship. These have never ran on...

I’m having a problem getting the outside door clips on to change the door locks—any tips would be great 👍🏾

I was changing a switch in the bedroom to one of those new fancy kind but it controls the outside lights on the patio. Issue is that you can also control the light from the kitchen as well. I need a 2 way switch I’m sure, but I’m a bit confused which way the wires go. I did not pay attention...

I have a weekend project. I’m going to change the underwood braces. I have these nice chrome looking ones that I want to replace the old ones with. They are much stronger as well problem is they are a bit longer, and the bolt that secures the older ones in is stuck. Is there an easier way to...

Looking for some chrome GN gas tank strsps

How do you remove the GN map light. It has these rivets that seem to need to come out

I have been thinking that I need a new light assembly on the middle of the headliner but I looked at it today and in the middle is there a wire that connects because the problem is that the light did not come on so I was going to replace it. But, if you look at the assembly on the picture that I...

Once again—I need the internals of a GN map light. I don’t need the outer housing. I have searched EBAY everywhere I can think of. Please help

Does anyone know where I can get a new clip for my door looks. I am changing my car door locks and lost the small inner one. Does anyone know where to purchase or anything that may work in its place…see picture. It goes on the little part that sticks out inside the door

Want to buy a dome light for my inside of my car. 1987 grand national

Selling my silver face Autometer boost gauge. It is about 2 years old. Only reason I swapped it out is for a carbon fiber one—going carbon fiber with all my gauges. It is a Procomp Ultra lite. It does NOT include the tubing. I just swapped them out—so I used the old hardware. 30 dollars plus...

Autometer Oil pressure gauge—Carbon Fiber auto lite. I just brought a carbon fiber boost gauge and they need to match

Recently had some medical issues and cannot lift or get on my back too much. Is there anyone around the Tampa area that can help me finish up removing my old one and installing my new Janis once it arrives..Yes, I will pay. Thank you...PM me for more details.

I changed all 3 locks, both doors and trunk now I think I misplaced the keys. Can they be re-keyed to fit the same key?

I brought a case and I was prepping it for paint, but o saw this…looks like it was grounded down or cut off in the corner. All holes are still intact. Are there any issues with this or can it be smoothed out and not affect anything. It is on the feet side right below a bolt hole

What paint do you use to paint a transmission case? I was thinking about rust oleum VHT I think it is?

Every pic I post says file too large. I want to post a few pics and ask what part this is but cannot

Can anyone circle the bolts that need to come out for a Tammy removal. I know there is 6. So after the first one I can take it from there. With the cover plate off it is confusing to me which one and I want to ensure I get the correct ones.

To whomever removed a granny, what size is this not—does it even come off?

Want to sell this loop. I want a round one onstrad