Search results

oooohhhh yourrrrr in trrrouble!!! what a a$$ wipe:)

body lean

brought gn last yr with some mods .. anyway just last wk i change chips because of not knowing what i had and not knowing what parameters the original chip has. the new chip is jim testa burnt with my known mods i did this for piece of mind but the old chip i.d says on a sticker e.p...

HOPE YOU SQUARE YOUR PROBLEM AWAY I HAVE SAME WITH 40*inj new wires coilpack plugs filter 17lbs boost it has been segusted that i go with higher octane fuel because of not knowing what chip is in the car

spring cleaning has been performed on this car as far as the fuel pressure i have it set at 40# at idle i also have fuel gauge that mounts directly to the schader valve with lucas 40# inj .do not know if there is a modify chip to match the inj, and the fuel pump is mounted outside the tank may...

BROUGHT THIS 87 GN THAT NEEDED WORK, AS FAR AS SUSPENISON,FRONT END,SHOCKS,TIRES. WELL ABOVE WORK IS FINALLY COMPELTED AND CAR IS INSP. TOOK IT OUT FOR A WOT PASS. MAN WAS I DISAPPOINTED!!! VERY LITTLE TORQUE, KNOCK GAUGE WAS IN THE RED AFTER BOOST WENT ABOVE TEN, THIS CAR HAS 40# INJ,ADJ...

your wot is a little low 3.86 sb 4.5 adjust bottom slot for wot

exhaust man problem i would use a bottom tap, of course using the same thread. there is always some room at the bottom of any drilled hole. the factory most likley used a starter tap which is taper at the lead to start the thread easier, bottom taps have very little lead so you can tap all the...

CAR IS FINALLY READY FOR INSP. EXCEPT IT DID NOT HAVE BKUP LIGHTS, WHICH I WOULD GET GIG FOR. SO I REPLACED THE SWITCH BUT NOW I HAVE BK UP ALL THE TIME WHAT AM I MISSING THANKS IN ADVANCE:confused:

KRIBANS SELLS A CRANK SENSOR TOOL FOR 29.00 WORTH ITS WEIGHT IN GOLD NO GUESS WORK

HAD THIS SAME PROBLEM, MY TRUNK LIGHT STAYED ON WHEN CLOSED. QUICK CK OPEN TRUNK PUSH IN PLUNGER :p

I DO NOT HAVE A SC, I USED A DIGITAL METER, SET TO DC PUT A SAFTEY PIN INTO THE MIDDLE LEAD AND GROUND THE BLACK LEAD. WITH THE KEY IN THE ON POSITION (ENGINE IS NOT RUNNING) CK. SB .42, THEN HAVE A FRIEND NAIL THE THROTHLE AND CK MEASURMENT AGAIN SB 4.5 OR A LITTLE ABOVE, IF NOT ADJUSTMENT IS...

reset both iac and tps to base settings

NEW TO THE SITE, BROUGHT A 87 GN IN JULY O1 HAVE BEEN WORKING ON IT FOR 6 MONTHS, I AM READY FOR SOME FINE TUNING AND WOULD LIKE TO START WITH THE TPS. COULD SOMEBODY WITH EXPERINCE GIVE SIMPLE AND I MEAN SIMPLE INSTRUCTIONS AS TO THE SETTINGS AND WHERE TO PLACE AND HOW TO USE JUMPER WIRES...