Search results

Figured it out. The wire for the clock on the radio is grounded out someplace. Previous owner installed new radio and rewired to fuse box and wasn’t using the clock wire. Unplugged it from the junction box and all good. Thanks

Unfortunately that once wasn’t it. I’ll keep digging.

Thanks will try when I get more fuses.

Hey folks my CLK-CIG circuit is not working. No interior light, no power door locks, cigarette lighter. Found a blown fuse, replaced and blew it as well. Obviously a short somewhere. Any hints on what the issue is before I trace down by isolating each draw?

Hey folks some knuckle head years back painted over the trunk label with the order codes on my GN. Anyone out there experience this and try to get paint off making the label legible? Thanks

Thanks Earl I got one.

Any Canadian folks have a 4 bolt gasket for the 3 inch exhaust they are willing to part with? Thanks

Thanks I have a new LS1 MAF and translator already

Bob did offer help but I think it’s my computers are the issue.

Yes need Bluetooth to get data. One computer won’t connect the other computer won’t seem to down load one of the files.

I do have a new O2 sensor but I will try reset if the ECU. Thanks

Hi folks, 87 GN. I done most of the basic upgrades fuel, chip etc. Car runs well with fresh plugs but a little rich during mid to full throttle. Now after a few short drives plugs seem fouled, missing and running rich (by smell) and wont idle. I have the Scanmaster G but can’t seem to connect...

Anyone offer advice for a ScanmasterG. I can’t seem to connect Bluetooth to my computer

Ya likely will do that over the next week or 2. I have a local guy who has a ECM. I will try that as well.

From G Body Caspers

I’ve gone back to stock chip and stock MAF. No code but now no start either. Not even firing now.

It did run not great. Added new fuel pump, new lines, filter, regulator. New MAF and translator was first thing and it ran but rough. Had the 33 and 34 code. But ran rough. Preceded on to the fuel system and chip upgrade from Aggressive think this should help but has continued to get worse...

Check all above all seem correct.

That’s what I have.