Anti-Theft Chip

[JACKH]

I want to make a chip image I can add to my 16 position thumbwheel that will make it so my car will not start. Anyone know what locations in the chip I need to change so the car will not start? I don't want it to just go into limp-home mode.... I want it not to start!

Jack
Jack@huisman.com

 

[BoostKillsStres]

You could probably set all the crank pulsewidths vs. temprature to zero.
Not sure if thats how its normally done but it would get the job done. I know when I was adjusting those values on my red stripes to try and make it crank a little faster, those inj spray like a fire hose, I had the values set too lean and it took quite a bit to start until I made the correction back in the other direction and this was just a little too lean not shut off totally.

 

[Eric Stage I]

On mine, all I did was set the rev limiter to 500rpm. It acts like it wants to start, but dies immediately. I figure this would prevent a thief from just cranking it until the battery dies.

Eric

 

[Scott231]

Another thing to do is to set the speed limiter to 1 MPH. So the car starts and idles fine. Put it in gear and ......