crashedout1
Active Member
- Joined
- Feb 23, 2011
Getting the kit I have hydroboost set up just wondering if I'm going to have issues?
Ssbc rear disc conversion kit from kegs?
- Thread starter crashedout1
- Start date
- Joined
- May 28, 2001
The issue with that kit was the bleed valves were right in line with the frame on the car. The first good bump would knock those valves off and the brake lines with it. Don't know if that has changed or not but have a look at it.
crashedout1
Active Member
- Joined
- Feb 23, 2011
I bought kit 884-a127
crashedout1
Active Member
- Joined
- Feb 23, 2011
Maybe a shorter bleeder
1986 Buick GX1
GX1 #001 [The One and Only]
- Joined
- Apr 24, 2015
I installed the SSBC kit in '92, I don't know the P/N.
After the second time the tips of the bleed screws broke off I just left them. This was with the stock height Moog cargo coil springs.
I've thought about grinding the nipple flat, but haven't yet. Now that I've installed the UMI 1" lowering springs (stiffer springs) I'll see how it does.
After the second time the tips of the bleed screws broke off I just left them. This was with the stock height Moog cargo coil springs.
I've thought about grinding the nipple flat, but haven't yet. Now that I've installed the UMI 1" lowering springs (stiffer springs) I'll see how it does.
crashedout1
Active Member
- Joined
- Feb 23, 2011
Use a shorter bleed screw or counter bore the hole on the caliper
