I've got the engine out to replace my transmission and also to find out where my oil leaks are coming from. Engine is a fairly fresh rebuild, and I think a majority of the leaks where coming from the back of the valve covers not fully seating because I use the rocker shaft braces. Anyhow, I'm also replacing the clicky comps so the intake has to come off. I noticed I must have cut the bottom of the PVC valve off (PVC valve still fully intact and clears the valley pan) because it won't fully seat with the valley pan in place. What's the consensus of the group on how to handle this? I'm thinking of making a cut in the valley pan so that the new PVC can fully seat. I've got a new PVC on order from one of the vendors here on the board. Thoughts everyone?