Thanks for the reply guys...for some reason, help>content doesn't work on this laptop. Just gives me a brief spinning donut...
Norbs...funny, I have the "unofficial manual printed from way back I think 2001 time frame. I was looking for the manual as I cant remember which hot key(s) corrected...
Intresting...never considered to check this. Results were
12.7 Battery voltage with multimeter
13.7 with car running and FAST dashboard
14.2 via multimetter with car running at the battery
There is a half a volt disparity...what does this mean?
The intake is a former Victor Jr. carbed converted to fuel injection. It has a 90 degree elbow to throttle body setup. The IAT is located on the elbow.
I really appreciate the feedback. I didn't realize it was running too lean at the top end...I recently upgraded the blower to an Si and did notice an extra pound of boost. To answer your question, the injectors are 83lbs and the opening time is .8. If you could point me in the right...
I've recently started tinkering with the Mustang again and decided to make some WOT logs to see how the car performed. Are there any issues that some of the old hats noticed with this particular log? I didn't notice anything but I am by no means an expert. Any assistance or tips would be greatly...
Can anyone assist in where to get a replacement O2 sensor for my classic FAST system? I've had the same one in the car now for going on 10 years and I'm thinking it probably needs to be replaced....
Paul
My trusty HP laptop finally bit the dust this past weekend. Unfortunately, it is impossible to find a new laptop with a serial connection. I've seen a USB to serial port adapter. Will this work with my legacy FAST? Anyone had any success with one?
Paul
Thanks for all the replies! After several years of troubleshooting (and headaches, temptation to sell, etc. etc.) I finally have figured out the problem. It turns out the cam I received didn't have the same amount of advance ground into it as the original...so installing it as I did the...
I replaced the original camshaft in my 408 with one supposedly identical in specs (the original cam had lobes going flat and was defective). The car ran great with the original cam but with the "new" cam, it runs terrible using the same tune.
After replacing/checking every component on the...
What is the best way to tune AE? I'm working on VE right now and I'm not really sure what I need to look for when tunning acceleration. How will I know if any AE is being applied?
I appreciate the quick reply...Thanks! I just realized what you are telling me. I did go thru my dash and took a few items out...and I bet thats what I did!!!!! Thanks again!!!!!!
Ive finally got around to working on my 86GT and have developed a crazy problem with FAST. During the VE table tuning, I've noticed the floating ball is reading the wrong RPM. Here is the kicker...all other tables and the dashboard are correct. What gives?
I played around with the table...