Recent content by FreddieWilliams

This item is still availible.......

Sold Sold........

Please see my ad on EBAY. Click Here Thanks,

Please see my ad on Ebay. Click Here Thanks,

Sold

Grand National / T-Type Valve Cover Extensions RJC 3/8" Aluminum Valve Cover Extensions Brand New. Never installed or used. No longer needed since I sold my car. $75 plus shipping __________________ Freddie Williams San Diego, CA TurboFreddie@yahoo.com

My left blinker is very very sloooooowww..... About 1 blink every 15 seconds. The right blinker is OK. 1 blink every second. I think the flasher relay needs replacing. Where is it located on a 87 Turbo Regal? TIA,

Who sells them?

What is the purpose of the restriction on the turbo compressor side of the plastic stock tee? Will I still need to use it with my external racegate and manual boost controller?

What size and where can I buy the 90 deg brass fitting that screws into the turbo compressor? I believe the threaded end is 1/8"-27 NPT but what size is the barbed end? 5/16" ID???? TIA,

Patrick, I have a Turbonetics compressor housing not a PTE ''H" but it seems to have the same problem...too big to fit within the stock location without interference. I was thinking cutting down the bypass nipple was the only fix I could see but wanted to get some other suggestions before...

I just installed a T70BB 4-bolt on-center turbo. The issue I ran into is that the compressor housing scroll is sitting on top of the water pump bypass hose. Any one run into this? If so, how did you solve this problem? Will try to post a picture tomorrow.

http://www.turbobuicks.com/resources/TurboBuicks.com_Torque_Spec.pdf

Looking for a downpipe (on center) SS or mild steel. Thx,

Sold Gone in 60 seconds......