Recent content by sparko112

  1. sparko112

    RJC pcv valve question....?

    the PCV grommet been replaced
  2. sparko112

    RJC pcv valve question....?

    thx, that's what I wanted to hear, Just thinking alittle sunshine....after reset the ecm....see what the blm's do?
  3. sparko112

    RJC pcv valve question....?

    I'm using the kirban's style hose with a check valve with the stock style PCV valve right now....But the stock pcv valve leaks, I hear over time.
  4. sparko112

    RJC pcv valve question....?

    so chuck it? my intake manifold gasket's etc...were replaced new/header welded etc ..
  5. sparko112

    RJC pcv valve question....?

    that sucks to hear. my blm's are half decent 136-137 within the TT chip +/-10. I know I have a vacumm leak and everything looks good, I'm thinking pcv or stock egr. egr block off plate is coming soon. I just have the rjc pcv valve and I heard good things. So what do you think ac-delco replacement.
  6. sparko112

    RJC pcv valve question....?

    What's the correct way to install the rjc pcv valve? I read in other posts some use the stock pcv and use this rjc pcv in the hose.... And other posts say that the rjc valve leaks?I would like to lower my blm's. I would appreicate any help. I have a new one but never installed it
  7. sparko112

    question?

    I got new moog replacement bushings for the front sway bar 1 1/4" . The stock clamps doesn't fit the new bushings.... Any ideas were to get the clamps? The original bushings are way smaller and worn out. part shops don't know, unless it comes in a kit.
  8. sparko112

    Rasing temperature at idle?

    Fan delay relay I agree. Needs replacement, Fan does not turn on after car is shut off for a couple of minutes or turns on when it's hot 168 drgrees or 173, O2's sensor not a problem. Engine is getting hot pretty quick at idle, Coolant temp sensor.Controls temp info to ecm and can cause issues...
  9. sparko112

    Rasing temperature at idle?

    When the car is cold, Once started after idling for about 10-15 minutes temperature gets warm 3/4 of the way on water gauge. The fan does not turn on. I think it's the CTS sensor(coolant temp sensor)it's originial, How do you replace this sensor?. I never did it before. The O2 readings are also...
  10. sparko112

    Commander Chip question...

    thx again...
  11. sparko112

    Commander Chip question...

    Thank you, Nice to hear. I don't need to adjust the chip or make any changes..It's just for the street, Ok then it's just plug in the ecm and that's all. thx for letting me know. I misunderstood the installation instructions then. I hear good thing about commander chip, works well.
  12. sparko112

    Commander Chip question...

    Is the commander chip just a plug and plug chip....From reading the instructions on the website it seems you have to connect a supplyed wire to something. Is this correct?
  13. sparko112

    Over heated won't start

    Aeah cookie monster. If it overheated temp, Maybe u might to replace the waterpump or maybe it could be the thermostat. Switch it to 160 and check the fan switching on/off when the engine is hot. If it doest start then check if there's fuel or the spark plugs/If not sure,take it to the...
  14. sparko112

    paper clip method...

    thx for explaining that
  15. sparko112

    paper clip method...

    Interesting link, thx..But the part I don't understand is the service light flashing. I get the first 3 flashs for code 12 to show ecm is working.. So now the next 3 flashs would be code 13 or if it was 4 flashs it would mean code 14 is this correct?