You can type here any text you want

1/4" Semi air brake vac hose?

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

GetOwnedVette

Active Member
Joined
Jun 13, 2006
Messages
765
Decided sooner or later I would like to bend stainless hard lines up for all my vacuum lines and had already purchased a ton of expensive AN fittings and hose to do my whole system. So returned the expensive AN stuff and have been looking for a cheaper and easy alternative to hold me over for a little while until I can go the stainless hardline route.

Has anyone went this route? Have any pics? Looking at my old mans car it looks very simple and clean to do. Only thing I noticed is the stuff doesn't like heat and can melt if it's touching something a little too hot.

EDIT: Not the rubber hose....the small plastic tubing. Sorry!
 
About 1000 miles since putting it back on the road. Even the lines to the compressor housing and the wastegate seem OK
 
What i was trying to say was I have about 75 ft left over in the garage. I'll send it to you for the postage. Of course it's NOT that expensive.
 
What i was trying to say was I have about 75 ft left over in the garage. I'll send it to you for the postage. Of course it's NOT that expensive.

Awesome! I really appreciate that man.....throw me your paypal in a PM and ill send you the cash and give you my address. I will even send back what I don't use which im sure will be a lot :)
 
Back
Top