4 and 5" exhaust

[that national]

does any one know where i can find 4 and 5" exhaust pices and bends so i can fab up my own down pipe

 

[sweetv6]

does any one know where i can find 4 and 5" exhaust pices and bends so i can fab up my own down pipe

I have 3-1/2 single and it is very hard to pass over the rear end
i need to change my upper arm for a slim one
i dont want to try with a 4

i think 4 is very too much

IMO

Claude

 

[Dewey]

Are you building a ricer? The standard 3.8 cylinder bore is 3.8 inches. Why would you need exhaust bigger than your cylinders? If you must have pieces that big you'll probably have to look into diesel applications.

 

[tom h]

http://www.burnsstainless.com