I finally have the GN engine in the car but need wiring diagrams for the firewall bulkhead connector as well as the clear one that goes behind the dash near the ECM for the Cutlass. It does not go to the ecm but is part of the harness.
I have all the diagrams for the GN harness, I need to know what pinouts to change or add on the Cutlass.
I know there are a few guys out there who have done this. I have the pinouts from the guy who did the Monte swap but I don't think the harneses are the same.
Help, anyone?
I have all the diagrams for the GN harness, I need to know what pinouts to change or add on the Cutlass.
I know there are a few guys out there who have done this. I have the pinouts from the guy who did the Monte swap but I don't think the harneses are the same.
Help, anyone?
