MPE Throttle Body ?

[Jbenn911]

Greetings all..
Just pulled off my MAF and intercooler hoses to clean them off ..Took a look at the TB and the blades have MPE printed on them...Fairly new owner here and wasnt able to learn all of what was done to the car from the owners widow or Dynotech(who made the car)..I do know that it's attached to a "modified" plenum..unsure if it is a modified stock unit or a Hemco, etc...TIA..

JB

 

[MoJoe]

Huh?

Do you have a question in there?

If MPE is stamped on the throttle blade, then there's good odds it is an MPE TB, or an MPE modified TB. Measure the throttle blade, or across the TB opening. I don't know the stock measurement, but it is smaller than the popular 65mm (2 9/16") and 70mm (2 3/4") upgrades.

Good luck, and have fun with the car!
Joe

 

[Jbenn911]

Thanks! WIll have to get to the garage and measure it..Trying hard to find out all what was done to the car as time goes on..Next is to figure out what a Stage III Turbonetics turbo is all about..Looked on their site and appears that mine is a bit older..Papework shows a fall of 2002 install date..After that is what kind of 36# injectors are on it and get a proper chip..btw, mease performance's site is down ....Thanks for the reply..


jb

 

[49-blues]

Keith usually puts his marked throttle blades in there after he modifies a TB- I have two of them done by him 65mm and he also puts new shaft seals viton i think- nice workmanship on it.