rebuild ta-49

[matt87gn]

I picked up a ta-49 on ebay in need of rebuild and was wondering, 1:where the best online site would be to find a diy kit and 2:the compressor wheel rubbed the housing and wore a little on the fins but housing is fine..... should this undoubtedly be replaced or could it maybe still be okay? thanx

 

[GNVYUS 1]

You might be able to buy a kit from Limit Engineering in AZ, I would recommend them rebuilding it, its only like $300.

Clean the cover and it will be fine, but your going to want a new wheel as its going to throw off the balancing when spinning over 100,000k rpm in there at high boost.

IMO, don't cheap out or you might be spending more to fix it again in the near future.