Replaced everything still `NO SPARK`

[y-hate]

i replaced everything like the ignition module and coilpack (new) camsensor (new) cranksensor twice (new) computer, check all fuses and ground wire,(new)plug wires and still no spark..........I`m thinking it might the wires in the coil pack not connected correctly what are the order as far as the the yellow, green, and blue wire, Is that the 1,3,5 wire but that is just a quess because i`m lost at this point..ANY HELP WILL DO THANKS

 

[TurboJim]

Originally posted by y-hate
i replaced everything like the ignition module and coilpack (new) camsensor (new) cranksensor twice (new) computer, check all fuses and ground wire,(new)plug wires and still no spark..........I`m thinking it might the wires in the coil pack not connected correctly what are the order as far as the the yellow, green, and blue wire, Is that the 1,3,5 wire but that is just a quess because i`m lost at this point..ANY HELP WILL DO THANKS

Even with the wires in the module connected wrong, you will have spark, just on the wrong cyls.

Is it possible you have the crank sensor in wring and the interrupter ring is in the wrong slot?

If not, you need to check powers and grounds..

 

[TurboShane]

http://www.rennie-macintosh.com/techarea/engine/ignitionmodule.jpg

 

[FJM568]

Take the cam sensor cap off and check to see if the metal cup is turning when you crank it over...If not, either the tab under the cup is sheared or the pin that holds the cam sensor shaft gear is sheared...

Or what Jim T said

 

[BobbyBuick]

Do you have an SES light with Key on ? .
Is the coil pack grounded ?