scan master 2.1?

[Raist103]

I am tiring to hook it up in the olds, I just swapped it out of the Gn and I don’t know what wire the feed can go too. I tired every wire on the back of the aldl none worked I want to know if you guys know what wire on the ecm I can hook it to work? I was going to post this in the hybrid section but it may be useful to those with aldl problems in the gns. If you know call 856-264-3392 eastern time till 10pm or tomorrow 9am-10pm or post up.

Thanks
Don

 

[pacecarta]

don , sorry i was out with hooper and jbenn , got in late and got your message on my ans machine , i left the answer you need on your voice mail .

you have the lc2 engine harness and 7148 ecm in that olds so just tap into A8 orange wire (smaller connector) at the ecm , ill fill you in on on the phone on how to get the olds ALDL usable for all scan tools so you can run a scanmaster

 

[Raist103]

got it paul thanks a bunch got it running tonight. found out the maf is bad now i got to find a good used one. o2s also will not go above 300, i wil swap in a new o2 sensor tomorrow it still has the stock reg. another problem may be that the fuel pump he has in line is not strong enough. i dont know what it is how much it flows but i am guessing not enough. but before i start to drive it i need a boost gauge in it maybe tomorrow before fuds i will do that or this weekend.