Selection of rod and main bearings. Which ones?

[Six_Silver]

I have read serveral posts and have gather these part numbers for main and rod bearings that members of this board are using:

Main bearings:
Clevite 77 MS960P
Federal Mogul 107M

Rod bearings:
Clevite 77 CB1443P (wide)
Clevite 77 CB1398H
Clevite 77 CB1228P
Federal Mogul 3755APA (wide)

My motor will have a steel crank so I was thinking about using the H series (harder) bearings. Or should I use the P series bearings? This will be a street/strip mid 10 sec motor in a full weight car.

I was leaning towards the MS960P's for the mains, but I am not sure on the rod bearings. Which of the 4 rod bearings listed above is best for my application? I am using stock rods.

 

[Six_Silver]

Also found:

Clevite 77 CB1348H rod bearings.

 

[Russ Merritt]

I run Clevite 77 960P mains CB1398 H rod bearings. Worked well so far.

 

[ITSAV6]

MS 960 P

Are they 3/4 groove mains?

 

[ITSAV6]

3/4 groove

After a call from parts store the dist called them back......release to be announced. Got the MS 960P mains and the 3755APA rods.