TPS not going past 3V WOT

[dank GN]

Hi just got off the Dyno and noticed my TPS was not going past 3.2 . I have a pressure transducer that is hooked to the 5v power from the TPS . Would this cause the volts not to go to 5? I have some more investigating to do but any input would be appreciated . Also would the TPS doing that cause the motor to not rev past 5k?

 

[Bescurred]

Did you try unplugging the transducer from the tips and checking it?

 

[dank GN]

Not yet but will try as soon as I can get back up to my Gn

 

[dank GN]

Okay so I found that the connection to the TPS had been spliced before me . I basically went and soldered them also why and I reading 5.1v at the MAF and 5 volts at the TPS main in shouldn't they be a steady 5V ? Also I have my FP transducer runnin off my TPS for its 5V power supply FYI . I forgot to get a reading at the ECM I believe it's pin C14?

 

[Bescurred]

Gnttype.org or vortex Buicks has the pin break down