I'm going through my engine for the third time. This time I'm putting the short block together myself. I had to pull the engine because of a rattle at 2000 RPMs which turned out to be three of the rod upper bearing wore out down to the copper. Engine had less than 800 miles on it. So I was lucky and only needed the crank polished and I had all of the rod checked. Two of the rods needed to be reconditioned. So now I'm looking for good bearings and gaskets to put it back together.
Rod bearings - I found King CR6616SI or Clevite H Series CB1398H
Main bearing - I found King MB443AM
Head gaskets - Victor Reinz or GM 25528486
Intake - Felpro MS96033
Pan?
Front and Rear main?
Just looking for part number so I can start ordering everything to get this back together. Here are the specs: 3.8L TE44, large neck intercooler, 42.5 injectors, 3" DP, 210/210 roller. Run at the track sometimes for fun, low boost 14-15 pounds on pump gas.
Rod bearings - I found King CR6616SI or Clevite H Series CB1398H
Main bearing - I found King MB443AM
Head gaskets - Victor Reinz or GM 25528486
Intake - Felpro MS96033
Pan?
Front and Rear main?
Just looking for part number so I can start ordering everything to get this back together. Here are the specs: 3.8L TE44, large neck intercooler, 42.5 injectors, 3" DP, 210/210 roller. Run at the track sometimes for fun, low boost 14-15 pounds on pump gas.