Wld87GN
Active Member
- Joined
- Feb 21, 2013
So I decided to make a few mods, nothing unusual:
60# injectors
6262 turbo
3 in down tube
upgraded SLIC intercooler
new headers
Precision stall convertor
alky kit
TT chip
all of the other typical upgrades you would expect.
So the problem is that 1/2 to 3/4 throttle it pulls hard, up to about 21-22# boost all is good. After that when I try for full throttle everything falls to sh!t.
I first thought fuel, but I tested fuel pressure, and I am good there.
I tried all new plugs and wires (just to eliminate possibilities)
The ONLY thing I can think is that I installed a new MAF and translator (it was used on another that did not have an issue about 2 years ago).
That is it... With that said, I love power up to about 3/4 throttle, after that... crap.
Any thoughts, suggestions?
60# injectors
6262 turbo
3 in down tube
upgraded SLIC intercooler
new headers
Precision stall convertor
alky kit
TT chip
all of the other typical upgrades you would expect.
So the problem is that 1/2 to 3/4 throttle it pulls hard, up to about 21-22# boost all is good. After that when I try for full throttle everything falls to sh!t.
I first thought fuel, but I tested fuel pressure, and I am good there.
I tried all new plugs and wires (just to eliminate possibilities)
The ONLY thing I can think is that I installed a new MAF and translator (it was used on another that did not have an issue about 2 years ago).
That is it... With that said, I love power up to about 3/4 throttle, after that... crap.
Any thoughts, suggestions?