dave82
Member
- Joined
- Jul 12, 2006
- Messages
- 90
Appreciate any assistance, mainly want to confirm I installed this correctly - I’m in the process of replacing my rear brakes, have new spring hardware and replacing the wheel cylinders as well since they were fairly rusted and I just did all new stainless lines so already had those off. I got the old retainer clip off and just installed the new wheel cylinder and clip. It appears to be fully seated and tabs are locked in but the wheel cylinder isn’t as tight as the original. Not sure if that’s just because the original had a lot of rust around it. I can shift the new one around slightly by hand and even very slightly rotate it. It’s not falling out so the clip is definitely holding it but seems to have more play than I was expecting. Is this normal? I haven’t proceeded with installing the shoes yet and spring hardware so maybe that will tighten it up but want to make sure I’m not missing something. Thanks