Recent content by SoGrand

Been trying to find an vacuum leak for 2wks. No error codes. tried smoke, pinching off hoses, using vacuum hand pump. Replaced iac and egr. tried squirting brakekleen around intake, vacuum block plenum etc. tried pinching hoses under dash. I have electronic climate control. sometimes pressing...

Thanks! I did up a whole blog. Maybe someone with answer!

I live on the coast of Central Jersey in Metuchen/ Woodbridge area. Cannot find anyone in the area that knows these cars. The only shop that worked on them closed down 13 years ago. No internet or phone book sightings. The only shop that shows up is tune time performance in Toms River NJ. I'm...

Thanks for all the concerns . I don' know how much I am able to post at one time? A relatively long post would give any readers the gist of where I am and would like to be even though I'm 64. Got a couple grand to play with as long As the wife eases up the pressure of her leg on the door of the...

Thanks Mr B. What would you consider to be the next best several moves then to bring up the hp torque etc. one fellow said 60# inj and a different chip. How do you know what chip would go with this lb inj? Pypes exhaust is coming. Does a torque converter finish this segment or is the stock TV...

Got it! The boost is set at 15. Talk about bursting bubbles!!

We can still get parts for this unit?(switches, etc)

I'm no saying this was the correct way of doing the pull, I just was asking that at about 220 hp, according to the printout shown after the pull, does the lb ft of torque sound close to being right, 519? All I was doing was to get an Idea of what the car had in it at this time with the little...

Was reading in the info guide by Peter Hoffman copy right 2005 pg 48. Keeping the brake fluid absolutely clean won't allow the sludge to form and clog the valve. He states to actually change the fluid every 6 months to keep it absolutely clean. I thought that was bit excessive. I called and...

I have an RA 93 chip, EX fuel pump, volt booster. Had a free chance at a dyno pull. I didn't have a tach so the operator went by ear the best he could. He hit 220 hp and said I was pushing 519 lb ft of torque. Does that sound right? Seems like a lot of torque for just a chip and pump change!

Was a welder for 40 yrs and did a lot of cutting (wizzers) and grinders. If your going to use one of these in the confined trunk are get a large mouth funnel, attach a strong shop vac to the spout end with duct or any tape and place the opening where the metal is flying to. Bring the spout in as...

Get a large mouth funnel and duct tape it into your shop vac hose. Place in front of the flying steel filings. Makes clean-up a whole lot easier.

Man, I have so much to learn! Thank you

Is the scanmaster and power logger the same thing?

I understand. Thank you!