Thanks for the info Nick. I know there are probably a lot of us considering that route for a future build. Watching, and listening to others experiences.
Is this the motor you are currently selling? http://www.turbobuick.com/forums/threads/polished-throttle-bracket-5500-mile-rebuilt-long-block-vacuum-brake-pedal-radiator-hold-down.411034/page-2
I didn't think I was in the minority, but I run the MT 275/60 on the factory GN wheels. I do have a 3/16 spacer on each side to stop them from rubbing on the frame. I have run this wheel/tire combo for years, and feel it works well for me.
Curious if anyone uses an RJC type valve along with the stock solenoid?
I have one of the BSTC electronic controllers along with dual stock solenoids. This setup controls boost well and gives me a wide range of adjustment while not tightening the actuator rod too much.
Just wondering if this...
Not to be an ass, but if you ebay your short block you might get what you pay for.
If you go Nick a well known vendor here, you can be sure you will get a quality rebuild.
If anyone needs an extra 5 gallons, I've found a shop in Carpentersville that is expecting to place an order within the week. 5 gallon container Sunoco 99.9% Methanol ~$46. I know its more expensive than having it pumped from a 55 gal, but at least you know its not contaminated. I you are...