toofastforyou
2FAST4U
- Joined
- May 25, 2001
Ok, I understand...Thanks Kevin for explaining!...So I'll order two of them like you posted from Mark!Claude, I can't make the entire area around the holes white, because this creates a relief engraving situation with the lettering--meaning, I'd have to engrave out everything BUT the letters. Because the letters are so small, even with the smallest diameter cutter tool I could come up with, tool would obliterate the lettering...
for example, notice the square holes in the plate, how nice & sharp the corners are? Well, imagine trying to get those sharp corners with a 3/8" diameter router bit--- you wouldn't, you'd almost end up with circles instead of squares. Same principle applies...
Oh yeah, what about the little square around the "L" led being colored green or red?...Can that be done?
Claude. :wink: