So the short version is i am not getting power to the pnk/blk wire that is a power feed to my ECM. getting no SES light, no fuel pump prime. ecm fuse is good. I was told there was a splice somewhere in the circuit that sends power to a few different systems.
My heater box is recently deleted and i noticed there was a pnk/blk wire or two in that circuit as well, could that be the problem?
This is on a fresh engine that has just been dropped in the car. new sensors replaced everywhere, etc.
Any help would greatly be appreciated!
My heater box is recently deleted and i noticed there was a pnk/blk wire or two in that circuit as well, could that be the problem?
This is on a fresh engine that has just been dropped in the car. new sensors replaced everywhere, etc.
Any help would greatly be appreciated!
Last edited: