Tom Tom Turbo
Turbo Goes Woo Woo
- Joined
- Jul 10, 2002
I'm about fed up with this motor I built a few years back. Its never sealed up right around the front cover. I've replaced the gasket twice, done the oil pan, etc. I've gone as far as to have the front cover machined (it was a HV aftermarket one and wasn't flat)
The car runs/drives fine until you build boost and then it pushes the front cover gasket out right around the oil pump. I'm guessing maybe a bad ring or something didn't seat right. The PCV system is all new (valve, lines, etc) but somehow I'm still getting some crazy crankcase pressure or something.
I've done all the work I care to do on this....does anyone have a suggestion for a shop around the Chicago/Central IL area that can take care of this mess?
The car runs/drives fine until you build boost and then it pushes the front cover gasket out right around the oil pump. I'm guessing maybe a bad ring or something didn't seat right. The PCV system is all new (valve, lines, etc) but somehow I'm still getting some crazy crankcase pressure or something.
I've done all the work I care to do on this....does anyone have a suggestion for a shop around the Chicago/Central IL area that can take care of this mess?