Fuel Pressure Transducer - Will this work with Powerlogger?

[robertmee]

SENSOR 100PSIG 1/8NPT 5V - P51-100-G-B-I36-5V-R

Basically, 0 to 100PSI, 12VDC input (I figure ignition power), 1 to 5VDC output. Half the price of the other one's I've seen on here.

There's also a .5 to 4.5V model....I'm assuming that either one I can set the appropriate curve in PL for fuel PSI?

 

[Boost231]

that one should work from what i can tell

 

[robertmee]

Just curious, but it states operating temp at 105 deg C (rougly 240 deg F). What's the operating temp of a TB engine on the outside? I assume as long as the T-Stat is working then it shouldn't be any more than the internal temp (160 to 170)....true?

 

[machinegun]

those temp working limits are for the fluid that the sensor will be used in.

I would ensure that the sensor has a gas rating as gas is usually prtty hard on stuff.

Should work though.

 

[robertmee]

those temp working limits are for the fluid that the sensor will be used in.

I would ensure that the sensor has a gas rating as gas is usually prtty hard on stuff.

Should work though.

Says any liquid suitable for stainless 304L & 316L....Best I can tell, gasoline is fine with those. Here's the manuf spec page....You can pretty much order them in any configuration....what size NPT should I get to go on the rail in place of the shrader valve? Is it 1/4?