I just received a precision water cooled turbo that I would like to install in the next few days before I park the car for six months.
I’ve seen people here hook it up to where the TB lines would normally go, I will enventually do this but the car has no heater system whatsoever.
I’ve also seen the one where the guy tapped new lines on to the intake and pump, clean set up for sure. But I don’t have time for that at the moment.
My idea is to put a fitting on the spot where the hard heater line goes, and take that to the upper side of the turbo. Then hook up the lower side of the turbo to the now capped spot on the water pump.
Would this set up work?
I’ve seen people here hook it up to where the TB lines would normally go, I will enventually do this but the car has no heater system whatsoever.
I’ve also seen the one where the guy tapped new lines on to the intake and pump, clean set up for sure. But I don’t have time for that at the moment.
My idea is to put a fitting on the spot where the hard heater line goes, and take that to the upper side of the turbo. Then hook up the lower side of the turbo to the now capped spot on the water pump.
Would this set up work?