scot w.
GNSperformance.com
- Joined
- Feb 19, 2005
- Messages
- 8,810
This kit replaces those flimsy wore out factory rubber shroud around the radiator jsut behind the grill. This was designed to divert 100% of the air that travels through the grill to be forced to go through the radiator!! The results: Better / Faster Cooling! Our kit is made from 1/16" Aluminum that comes factory coated in Gloss black with a protective film on each side to prevent scratches during installation. Remove the protective film to reveal the glossy finish. An Anti-Rattle strip has already been Pre-installed to insure quietness. (Very minor notching required if using an external cooler, very easy to do with some snips).
Mounting: This kit mounts right behind your grill to the ( X ) brace that is mounted to your core support. Simply remove the two 10mm bolts from One side, leaving the cross brace there, mount the correct side of the box-in kit right over the cross brace and bolt it back up. Do the same to the other side now just remove the two bolts holding on the two corners of your air dams (under the center of your car screw the bottom section on, Bolt your air dams back on and your done!
NOTE: For Turbo Regals this kit is best suited for use with ALL Stock Location Intercoolers. (This kit can be used with front mounts but some minor notching is required!)
No drilling required! The holes have already been pre-drilled and ready to install.
Kit comes complete with all mounting hardware and instructions.
Kit Includes:
Bottom & Both sides of the air box.
6 sheet metal screws.
4 Push clips (pre-installed)
Complete instructions
Price: $107.00
Visit our Link here to purchase -----> http://www.gnsperformance.com/bodyframe-g-body
Scot W.
Mounting: This kit mounts right behind your grill to the ( X ) brace that is mounted to your core support. Simply remove the two 10mm bolts from One side, leaving the cross brace there, mount the correct side of the box-in kit right over the cross brace and bolt it back up. Do the same to the other side now just remove the two bolts holding on the two corners of your air dams (under the center of your car screw the bottom section on, Bolt your air dams back on and your done!
NOTE: For Turbo Regals this kit is best suited for use with ALL Stock Location Intercoolers. (This kit can be used with front mounts but some minor notching is required!)
No drilling required! The holes have already been pre-drilled and ready to install.
Kit comes complete with all mounting hardware and instructions.
Kit Includes:
Bottom & Both sides of the air box.
6 sheet metal screws.
4 Push clips (pre-installed)
Complete instructions
Price: $107.00
Visit our Link here to purchase -----> http://www.gnsperformance.com/bodyframe-g-body
Scot W.
Last edited: