- Joined
- Jun 18, 2001
- Messages
- 1,459
I am changing directions on my engine program and selling parts from my back up motor. No I am not going LS but I am finally switching to a Stage 2 head. I have most of the hard to get parts to put together an entire TA head S2 on-center motor. I am willing to finish it and sell as a complete motor assembled and installed, or I will sell the top end, crank rods pistons but not the block. I do not have a price for a complete build, it would depend on a lot of different factors which would need to be discussed but parts alone to complete this build will be close to $20k.
BNIB, TA performace SE head castings. These are bare castings with guides and seats.
BNIB GN1 intake for On-Center block, I will sell as package with head castings for $3500 firm, I will not separate.
6.5" Oliver Billet rods with BNIB rod bolts from Oliver. $900
The pistons Diamonds for TA heads, They have VERY Low run time no passes at the drag strip. They are a 1.340 Compression Ht, 28cc dish, will take a 4.023 finished bore. With a 3.625 crank and 6.35" rod you would be at a 9.5025 ht. I have the build sheet on these $500. With a 3.4" stroke crank they would be at 9.54 deck ht using 6.5" rods listed above.
4.1 On-Center S2 153 block VERY nice and finished machined. It is only for sale as an entire build, bore is 4.015 waiting for finish hone deck ht is 9.510 with finished decks Again not for sale separately only as an entire build.
BMS 3.625 forged Crankshaft Std/std mint. $2500
BNIB BHJ Balancer does not have factory timing ring, $450
BNIB Weber 212/206 Billet roller cam $500, I may have some of the parts for the Weber style cam stack up or it can be cut for a Danny Bee/ TA perf style stack up.
More to come I will be at BG tomorrow with this stuff
BNIB, TA performace SE head castings. These are bare castings with guides and seats.
BNIB GN1 intake for On-Center block, I will sell as package with head castings for $3500 firm, I will not separate.
6.5" Oliver Billet rods with BNIB rod bolts from Oliver. $900
The pistons Diamonds for TA heads, They have VERY Low run time no passes at the drag strip. They are a 1.340 Compression Ht, 28cc dish, will take a 4.023 finished bore. With a 3.625 crank and 6.35" rod you would be at a 9.5025 ht. I have the build sheet on these $500. With a 3.4" stroke crank they would be at 9.54 deck ht using 6.5" rods listed above.
4.1 On-Center S2 153 block VERY nice and finished machined. It is only for sale as an entire build, bore is 4.015 waiting for finish hone deck ht is 9.510 with finished decks Again not for sale separately only as an entire build.
BMS 3.625 forged Crankshaft Std/std mint. $2500
BNIB BHJ Balancer does not have factory timing ring, $450
BNIB Weber 212/206 Billet roller cam $500, I may have some of the parts for the Weber style cam stack up or it can be cut for a Danny Bee/ TA perf style stack up.
More to come I will be at BG tomorrow with this stuff
