Temp Sensor -38 on scanmaster correct on PL

[czimpel]

I have an issue where my temp sensor is reading -38 on my scanmaster, but reads correctly on the PowerLogger. Car starts hard when cold, so assuming this is causing the issue. Is this just a bad TS or do I have a wiring issue. Just reinstalled the motor, so wires were being moved around.

Thanks, Cory

 

[rmar]

Cory you need to move. It probably-38 still outside there.
On a side note I believe -38 is default if it has no reading.

 

[rmar]

Check your coolant sensor. Drivers side intake manifold. 2 wire. Unplugged or borked.

 

[czimpel]

Thanks Ronnie, I'll try start there. Where does the powerlogger pull its temp data from?

 

[czimpel]

That was it Ronnie, plug was laying in the socket, but never got plugged in all the way. I thought there were only the 2 temp sensors. Learning everyday!

 

[rmar]

Thanks Ronnie, I'll try start there. Where does the powerlogger pull its temp data from?

Somewhere else...............

 

[czimpel]