Recent content by 3.8na
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
3
Anything new in headlights for our cars?
I try not to drive too much at night these days. Hell, even during the day I have my H6054's on.- 3.8na
- Post #19
- Forum: Electrical & Wiring
-
3
Some top end teardown pictures.
A shout out to BadAssGN, windshearalert and TurboBuRick for their heads up on this older thread... https://www.turbobuick.com/threads/headgasket-installation-with-studs.309697/ ...about brake parts/brake cleaner vs acetone or electrical contact cleaner or lacquer thinner on gasket surfaces...- 3.8na
- Post #7
- Forum: Before Black (non-SFI) Tech
-
3
Breaking down my stock motor
Very NICE! Digital pictures, masking tape and sharpie pen help for re-assembly!- 3.8na
- Post #8
- Forum: Engine Tech
-
3
Some top end teardown pictures.
On my new intake kit (MS96033) I see that there are notches on one side of the end seal's , and not the other. I might have had the front seal 180 out which would have created a flashing problem.- 3.8na
- Post #6
- Forum: Before Black (non-SFI) Tech
-
3
Some top end teardown pictures.
I have two torque patterns showing up for the cylinder heads. Looks like they changed the pattern for 83-87, or possibly 85-87 and also the specific procedure for maximum torque (90 degrees tighter or 60 lb-ft Max.) Then on to next fastener. Anyone watching able to clarify? I am going with...- 3.8na
- Post #5
- Forum: Before Black (non-SFI) Tech
-
3
Went to a show earlier.
It was more than I wanted to spend. Can you tell me anything about the model?- 3.8na
- Post #3
- Forum: GUNS & AMMO
-
3
Blowthrough build repeat.
It is listed on a Facebook Market page in Dallas, OR I believe if anyone is interested. It's got the badge on the hood.- 3.8na
- Post #22
- Forum: Before Black (non-SFI) Tech
-
3
Green connector? (Computer controlled carb/distributor)
(Or should I have said 79 1/2?)- 3.8na
- Post #5
- Forum: Before Black (non-SFI) Tech
