Recent content by 79monte
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
7
need advice about building 200r4
hey do you guys know if any of the shift kits for the 200-r4 involve modification to the valve body or the case? i just wanna know if i can take the valve body and spacer off my old tranny and put it on the new one without problems?- 79monte
- Post #19
- Forum: Transmission Talk
-
7
need advice about building 200r4
unfortunetly i dont have to money to spend on it right now, so ill have to let that go, thankyou though. starting my new job monday so should have some money flowing then. i was thinking though the old tranny was built so it must have an aftermarket drum in it, so i should steal that one.- 79monte
- Post #15
- Forum: Transmission Talk
-
7
need advice about building 200r4
okay so im thingking a new a shift kit for the new tranny since im not sure what kind is in the old one and what they did to it, so i feel a new one would be good to avoid possible shifting problem headachs. and a new billet front drum. will the clutches and the rest of the tranny hold 400 hp...- 79monte
- Post #10
- Forum: Transmission Talk
-
7
need advice about building 200r4
ive had a few ppl say its fine to just swap parts, witch is awesome! can you guys think of any problems i might run into or certain things i should look for or pay special attention to?- 79monte
- Post #6
- Forum: Transmission Talk
-
7
need advice about building 200r4
i noticed that the output shaft is sloppy or loose on my first tranny and i checked the good one and its the same way. is that normal for these transmissions?- 79monte
- Post #3
- Forum: Transmission Talk
-
7
need advice about building 200r4
okay i had a very nice built 200r4, built to handle 450hp, it came to a very violent end at 103mph when the drive shaft seems to have let go and in the process cracked the bell housing off. i drove to pensilvania and picked up a stock 200r4 20k off a rebuild. i want to build this to handle the...- 79monte
- Thread
- Replies: 19
- Forum: Transmission Talk
