Recent content by 84gnguy
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
8
where to buy the fan ballast thats located on the fan shroud,87 GN
mine is missing a chunk out of it..where the connector or terminal is attached...where can I buy one..or can it be bypassed and is it OK to do so...thanks in advance Did a search...by bad..should have did that first!- 84gnguy
- Thread
- Replies: 1
- Forum: General Turbo Buick Tech
-
8
engine smokes at start up
Limit Engineering can rebuild your stock turbo or you can buy one thru Kirbans Performance- 84gnguy
- Post #2
- Forum: Turbos and turbo related parts
-
8
New best and looking for more, time slip, video and PL file.
being a Chevelle guy (68-72 A-bodies in general) and a turbo Buick guy,that is one awesome ride!! Nice run!!- 84gnguy
- Post #26
- Forum: General Turbo Buick Tech
-
8
Whats it worth: stock turbo
Has a little more than acceptable shaft play and just started to smoke,so its a core. Thanks in advance...- 84gnguy
- Thread
- Replies: 2
- Forum: General Turbo Buick Tech
-
8
Pump Gas 93 Record?
Thats amazing...and all the more reason I plan on keeping my car a pump gas combo with no alky- 84gnguy
- Post #19
- Forum: General Turbo Buick Tech
-
8
MAACO Paint Job Buicks
Nice!! I had my 87 painted at Maaco five years ago.I can't complain. Go for the BC/CC its worth the little bit extra. I took off all the emblems and moldings,cleaned and touched up the trim and reinstalled myself after I got the car back. I have had a few cars painted by them over the...- 84gnguy
- Post #24
- Forum: General Turbo Buick Tech
-
8
Neat low cost upgrade thread
I bought a very nice used Hooker exhaust system for $150..after I installed it...I sold the wasted,factory catyltic convertor that was on the car for $100 to the local scrapyard and someone bought the stock exhaust off the car that had the Flowmaster crossflow muffler for $50- 84gnguy
- Post #15
- Forum: General Turbo Buick Tech
-
8
Rear End Help
Auburn units suck,plain and simple. Eaton is always my choice- 84gnguy
- Post #7
- Forum: General Turbo Buick Tech
-
8
Converter Questions
4000 flash sounds about right for a convertor that rated for 3600- 84gnguy
- Post #2
- Forum: Transmission Talk
-
8
octane needed for 17 lbs. boost/26*
the chip in question that has 26* of timing is a stock 1989 turbo TA chip http://www.turbobuick.com/forums/turbo-trans-am-tech/170691-question-about-tta-vs-gn.html- 84gnguy
- Post #5
- Forum: General Turbo Buick Tech
-
8
octane needed for 17 lbs. boost/26*
Curious as to what octane I would need with 17 lbs boost/ max of 26* of timing The turbo tweek 93 octane street chip I have has the same 17 lbs. of boost,but has 19* of timing thoughts?- 84gnguy
- Thread
- Replies: 4
- Forum: General Turbo Buick Tech
-
8
GN worth the money?
All I know is,when I bring a car to the painter that I did all the bodywork to and prepped,its isn't $8K for paint.- 84gnguy
- Post #17
- Forum: General Turbo Buick Tech
